- Joined
- Jun 4, 2018
- Messages
- 37
Perhaps I'm just not understanding (it could happen...) but, I trammed the head per the manual and got it within.0005 from one end in relation to the other. So, then I got curious. By putting an indicator in the quill I wanted to see how 'true' the table runs from one end to the other in relation the quill position. If I start from right to left, stop to stop, it indicates within .0005 at each end. However, throughout the traveling distance the indicator picks up a .0015 'dish' toward the middle of the table.
Any reason I should be concerned about that...?
Thank you all!
Any reason I should be concerned about that...?
Thank you all!