- Joined
- Mar 20, 2014
- Messages
- 439
I just finished reading a long running thread on a Grizzly G0755 mill, started in 2013 ( "New Grizzly G0755 is set up and running"). This mill is basically the same machine as my 932. One of the posts in that thread said that the specs for torqueing the 4 column bolts is 121 ft. lbs. That seems really high to me. When I first got my mill, I used a torque wrench to loosen my bolts so that I would know how tight they were, and it only took around 45 ft. lbs. to loosen them. HOWEVER, I'm not sure if the loosening torque is directly proportional to the tightening torque. All advise on my mill as well as advise on correctly torqueing appreciated. Thanks, JR49