A
Alan H.
Forum Guest
Register Today
I am looking for ideas on how to manage all the electrical cords and cables on my new mill. I have the following to contend with:
I have seen examples of an added 110v receptacle box to the mill for 110v power and thereby eliminating multiple plugs leaving the mill to the wall.
In addition, I hate stuff dangling in the air! So I am looking for ideas on how to organize and hold this stuff down. Have you found any stick-on wire holders that will last in the oily environment?
Thanks for the help.
- DRO input cables.
- DRO power plug
- Light plug (light not yet acquired)
- Table power feed - limited switch cable, power cable
- more to come?
I have seen examples of an added 110v receptacle box to the mill for 110v power and thereby eliminating multiple plugs leaving the mill to the wall.
In addition, I hate stuff dangling in the air! So I am looking for ideas on how to organize and hold this stuff down. Have you found any stick-on wire holders that will last in the oily environment?
Thanks for the help.