- Joined
- Aug 19, 2014
- Messages
- 225
>I noticed others using this vise found an equivalent to the "Quickie" vise handle.
Can't help with the Glacern specifically, but I bought a use-enco.com #337-9316 on sale. It didn't fit my 4" vice. So what I did was find a socket (I think 10mm) that did fit the vice shaft, then bored out the hex part of the quickie handle and pressed in the socket. Good enough.
Can't help with the Glacern specifically, but I bought a use-enco.com #337-9316 on sale. It didn't fit my 4" vice. So what I did was find a socket (I think 10mm) that did fit the vice shaft, then bored out the hex part of the quickie handle and pressed in the socket. Good enough.