- Joined
- Nov 12, 2012
- Messages
- 217
i just installed the LMS belt drive on my HF 44991 mini mill.
when it's in the high speed config, the spindle stops turning if i ry to set the speed up very far.
is this normal?
the directions say to increase speed slowly in high, but this seems a little to sensitive to me.
dint see the problem in low epeed at all
TIA
when it's in the high speed config, the spindle stops turning if i ry to set the speed up very far.
is this normal?
the directions say to increase speed slowly in high, but this seems a little to sensitive to me.
dint see the problem in low epeed at all
TIA