- Joined
- Sep 8, 2019
- Messages
- 4,392
I was too tired from my work week to even touch this project yesterday. Today (Sunday) I drilled the 3/4” and 1-1/4” holes in the last shelf.
I also did a quickie (flap disk) knocking down the high points (which were the high parts of 3 bolt heads) on the back side of the shelf.
Now I am going to make the last 3 posts. These are made from 1-1/4” muffler tubing. So I spent about 5 hours of my day on the knee mill, and my evening will be on the engine lathe.
![B5094F9C-3162-4CB8-988C-4AF87642F2A5.jpeg B5094F9C-3162-4CB8-988C-4AF87642F2A5.jpeg](https://www.hobby-machinist.com/data/attachments/372/372180-baf1869a61321e87220a772aa3d7bc85.jpg)
![D8FC6659-C1E6-41AD-B704-AF73F3FDA3C1.jpeg D8FC6659-C1E6-41AD-B704-AF73F3FDA3C1.jpeg](https://www.hobby-machinist.com/data/attachments/372/372181-3785000cc47ef70048b9cb171960371f.jpg)
![5633CCA2-3AAF-4D31-AF31-7929035589F3.jpeg 5633CCA2-3AAF-4D31-AF31-7929035589F3.jpeg](https://www.hobby-machinist.com/data/attachments/372/372182-95979aa145ada56d7f188377b5d54412.jpg)
I also did a quickie (flap disk) knocking down the high points (which were the high parts of 3 bolt heads) on the back side of the shelf.
Now I am going to make the last 3 posts. These are made from 1-1/4” muffler tubing. So I spent about 5 hours of my day on the knee mill, and my evening will be on the engine lathe.
![B5094F9C-3162-4CB8-988C-4AF87642F2A5.jpeg B5094F9C-3162-4CB8-988C-4AF87642F2A5.jpeg](https://www.hobby-machinist.com/data/attachments/372/372180-baf1869a61321e87220a772aa3d7bc85.jpg)
![D8FC6659-C1E6-41AD-B704-AF73F3FDA3C1.jpeg D8FC6659-C1E6-41AD-B704-AF73F3FDA3C1.jpeg](https://www.hobby-machinist.com/data/attachments/372/372181-3785000cc47ef70048b9cb171960371f.jpg)
![5633CCA2-3AAF-4D31-AF31-7929035589F3.jpeg 5633CCA2-3AAF-4D31-AF31-7929035589F3.jpeg](https://www.hobby-machinist.com/data/attachments/372/372182-95979aa145ada56d7f188377b5d54412.jpg)