- Joined
- Feb 2, 2013
- Messages
- 3,637
Hi Kerry
i would really be interested in the RPC's output at this point. i think you mentioned it worked for other motors.
dumb question what is the RPC rated for or how many HP is the motor on the RPC?
if we are trying to start a 3hp 3phase motor with a 1.5 hp RPC we will have some problems for sure.
we have basically ruled out the unisaw motor fault, the windings are not open or highly resistant, there doesn't appear to be shorts to ground.
we are pointing to controls after we determine RPC output
i would really be interested in the RPC's output at this point. i think you mentioned it worked for other motors.
dumb question what is the RPC rated for or how many HP is the motor on the RPC?
if we are trying to start a 3hp 3phase motor with a 1.5 hp RPC we will have some problems for sure.
we have basically ruled out the unisaw motor fault, the windings are not open or highly resistant, there doesn't appear to be shorts to ground.
we are pointing to controls after we determine RPC output
Last edited: