- Joined
- Feb 23, 2013
- Messages
- 152
Hey Mike,
Finally got the motor back in the saw and making some sawdust again. The problem was when I wired up the outlet to the RPC I mistaken the "Z" screw hole
on the outlet for the GROUND . When I took it apart I made the switch to the correct ground "W" on the outlet, it all worked fine. Well the saw needed a cleaning and some
lubrication anyway!
Regards.............Kerry
Finally got the motor back in the saw and making some sawdust again. The problem was when I wired up the outlet to the RPC I mistaken the "Z" screw hole
on the outlet for the GROUND . When I took it apart I made the switch to the correct ground "W" on the outlet, it all worked fine. Well the saw needed a cleaning and some
lubrication anyway!
Regards.............Kerry