- Joined
- Sep 26, 2013
- Messages
- 408
I have this motor and controller, is it worthwhile to install the system on my 8530? Running an AC 3/4hp on the mill now. As I understand it the tread mill motors are also shunt wound, but most are rated at a greater hp(optimistically). Given the beefiness of my motor its hard to believe the typical treadmill motor is stronger than the one I have. Thoughts??
thanks, Brian
EDIT: sorry I asked this same question( http://www.hobby-machinist.com/threads/shunt-wound-dc-motor-on-clausing-8530-mill.41050/ ) when I got the 8530 this came with, so upon reading it I see the question was pretty much answered. Still like any additional input
thanks, Brian
EDIT: sorry I asked this same question( http://www.hobby-machinist.com/threads/shunt-wound-dc-motor-on-clausing-8530-mill.41050/ ) when I got the 8530 this came with, so upon reading it I see the question was pretty much answered. Still like any additional input
Last edited: