- Joined
- Jul 10, 2013
- Messages
- 102
Hi all,
I am in need of advice for a problem here in the shop. I have a hole in a 1/32 thick sheet of stainless i need to fill. A guy here tried to fill a very small tear in the material with tig welding but ended up making a hole. Further attempts ended up enlarging the hole.
I wondere if silver brazing could be done. This is 1/32 stainless steel, hole is rectangular'ish 3/16x 3/8.
I have never done that. All tips are welcome. What I have on hand now is a small roll of silver, some silver brazing flux, propane torch and oxy acetylen torches and good will
Thanks for any input
I am in need of advice for a problem here in the shop. I have a hole in a 1/32 thick sheet of stainless i need to fill. A guy here tried to fill a very small tear in the material with tig welding but ended up making a hole. Further attempts ended up enlarging the hole.
I wondere if silver brazing could be done. This is 1/32 stainless steel, hole is rectangular'ish 3/16x 3/8.
I have never done that. All tips are welcome. What I have on hand now is a small roll of silver, some silver brazing flux, propane torch and oxy acetylen torches and good will
Thanks for any input