The multi-speed pulley (C) on the headstock doesn't line up with the intermediate set (B.
Putting a straight edge between them, they are off about 1/16" and I am seeing a lot of belt "dust" (for lack of a better word) inside the guard.
In my mind they should be aligned for best results.
I am looking for a spanner wrench to fit so I can shim the pulley out.
The thought of putting a pipe wrench on the machined nut goes against the grain with me.
Any suggestions,
Bill
Putting a straight edge between them, they are off about 1/16" and I am seeing a lot of belt "dust" (for lack of a better word) inside the guard.
In my mind they should be aligned for best results.
I am looking for a spanner wrench to fit so I can shim the pulley out.
The thought of putting a pipe wrench on the machined nut goes against the grain with me.
Any suggestions,
Bill