Hello All.
I believe my lathe spindle has an MT3. The thread on the spindle is 1-1/2 x 8. I'm wondering if there's a set of collets that will fit inside the spindle and a retaining/clamping nut that matches the spindle thread. I have a three jaw self centering chuck that holds 1/4 round bar, but it's not centering properly. I have a manual center 4-jaw but it wont hold such small material. I'd rather not use a drill chuck in the spindle since I'd like to still have the advantage of through hole.
Thanks,
John
I believe my lathe spindle has an MT3. The thread on the spindle is 1-1/2 x 8. I'm wondering if there's a set of collets that will fit inside the spindle and a retaining/clamping nut that matches the spindle thread. I have a three jaw self centering chuck that holds 1/4 round bar, but it's not centering properly. I have a manual center 4-jaw but it wont hold such small material. I'd rather not use a drill chuck in the spindle since I'd like to still have the advantage of through hole.
Thanks,
John