- Joined
- Dec 7, 2018
- Messages
- 653
My knee mill which has been in use about 10 months and only sporadically as this is a hobby not a business. I was using it making some small parts and after I changed the tooling on the end it just wouldn’t kick into full speed when I turned it back on.
The manufacturer responded quickly with parts and I am back up and running after a few days.
My question is, given my little use, how often do these contacts get burned enough to inhibit full speed from engaging when turned on?
The manufacturer responded quickly with parts and I am back up and running after a few days.
My question is, given my little use, how often do these contacts get burned enough to inhibit full speed from engaging when turned on?