- Joined
- May 7, 2018
- Messages
- 174
I have been looking at steady rests for a while now and have done some research for building one. I don't have a milling machine and my lathe skills are very limited. I started by buying the roller bearing fingers. Then I found out they were not long enough for the size steady rest I decided.to build dictated by the size pipe I found to use. I think I may have a solution. Here is where I am so far. I have never used a steady rest so I'm only guessing it will be strong enough structurally.
Thanks for looking.
Jay
Thanks for looking.
Jay
Last edited: