- Joined
- Oct 16, 2019
- Messages
- 6,596
Ages ago I bought an Ender 3v2 so that I could print the parts for my PrintNC CNC router build.
Well after a few kgs’s (likely 20 or so) of filament it was basically worn out and required a lot of tuning to get it to print consistently.
So I sold it for parts and bought a Sovol SV06.
Totally impressed by the machine as it just flat out worked right out of the box and the print quality was head and shoulders above the Ender.
Today I got around to installing the Klipper upgrade from Sovol.
Dead simple to do, maybe 10 mins to do the mechanical bits and about 30 seconds to configure the slicer.
The increase in printing speed is just astonishing.
A print that would have taken an hour is now done in 18 minutes with zero quality degradation.
Well after a few kgs’s (likely 20 or so) of filament it was basically worn out and required a lot of tuning to get it to print consistently.
So I sold it for parts and bought a Sovol SV06.
Totally impressed by the machine as it just flat out worked right out of the box and the print quality was head and shoulders above the Ender.
Today I got around to installing the Klipper upgrade from Sovol.
Dead simple to do, maybe 10 mins to do the mechanical bits and about 30 seconds to configure the slicer.
The increase in printing speed is just astonishing.
A print that would have taken an hour is now done in 18 minutes with zero quality degradation.
Last edited: