- Joined
- Apr 23, 2011
- Messages
- 2,476
Picked up a Tool & Cutter Grinder and slowly overhauling it. I have done the tool holder but there a couple of bits missing that I would like to try and identify and a question about the collet holder.
There is a blind hole in the side of the head with a thumbwheel screw to tighten the "missing" piece in place.
Any guesses as to what gets secured in here?
And on the top machined surface there are 2 tapped holes for securing something in place there.
It did come with a homemade thingy of sorts that seems to fit in place but I cant work out what it might do. It is slotted for adjustment/positioning but there is no facility for lowering the vertical rod. (Not that it looks like it would serve any purpose to do so)
Any guesses as to this accessory?
Cheers Phil
There is a blind hole in the side of the head with a thumbwheel screw to tighten the "missing" piece in place.
Any guesses as to what gets secured in here?
And on the top machined surface there are 2 tapped holes for securing something in place there.
It did come with a homemade thingy of sorts that seems to fit in place but I cant work out what it might do. It is slotted for adjustment/positioning but there is no facility for lowering the vertical rod. (Not that it looks like it would serve any purpose to do so)
Any guesses as to this accessory?
Cheers Phil