- Joined
- Mar 14, 2014
- Messages
- 175
Here's my take on a tramming tool, it's not cleaned up yet just finished.
centering in my 4 jaw chuck.
![center.jpg center.jpg](https://www.hobby-machinist.com/data/attachments/87/87820-d9961ca5be38d36d6458b810b4a71fc8.jpg)
then I drilled it out.
![drill.jpg drill.jpg](https://www.hobby-machinist.com/data/attachments/87/87822-0d70b0864730fe8a5e0e2dab4c23aef5.jpg)
I trued up the top and bottom.
![turning.jpg turning.jpg](https://www.hobby-machinist.com/data/attachments/87/87823-ff16f7ebc552096ea3a831371dcdce09.jpg)
Heres the almost finished project.
![tram.jpg tram.jpg](https://www.hobby-machinist.com/data/attachments/87/87824-b90c56e1b0a2a546b19630a4a93d4723.jpg)
I did most of the work on my lathe, because i had no way to tram the vertical head I installed on my horizontal mill.
centering in my 4 jaw chuck.
![center.jpg center.jpg](https://www.hobby-machinist.com/data/attachments/87/87820-d9961ca5be38d36d6458b810b4a71fc8.jpg)
then I drilled it out.
![drill.jpg drill.jpg](https://www.hobby-machinist.com/data/attachments/87/87822-0d70b0864730fe8a5e0e2dab4c23aef5.jpg)
I trued up the top and bottom.
![turning.jpg turning.jpg](https://www.hobby-machinist.com/data/attachments/87/87823-ff16f7ebc552096ea3a831371dcdce09.jpg)
Heres the almost finished project.
![tram.jpg tram.jpg](https://www.hobby-machinist.com/data/attachments/87/87824-b90c56e1b0a2a546b19630a4a93d4723.jpg)
I did most of the work on my lathe, because i had no way to tram the vertical head I installed on my horizontal mill.