- Joined
- Jul 20, 2014
- Messages
- 1,386
I've always wondered how small diameters of round stock rods were turned down without a taper or flex.
I found this great example of technique.
http://modelenginenews.org/techniques/stepturn.html
Having a good lathe with good gibs and ways, etc,.. is very important. When I finally find a good lathe, I will be sure to check it for any severe wear and tear. Enjoy.
I found this great example of technique.
http://modelenginenews.org/techniques/stepturn.html
Having a good lathe with good gibs and ways, etc,.. is very important. When I finally find a good lathe, I will be sure to check it for any severe wear and tear. Enjoy.