- Joined
- Feb 28, 2019
- Messages
- 502
I'm just not sure about this....
Is the flat on this stubby 1/4" end mill going to mess up my ER11 collet?
There is a small amount of solid shaft between the flat and the flutes. I'm thinking that I should choke up on it such that the open end of the collet sees a full round shank.
The other / back end of the shank is about .4 and less that 2X the diameter. It seems like a bad idea to have only that in the collet.
Am I over thinking this?
Is the flat on this stubby 1/4" end mill going to mess up my ER11 collet?
There is a small amount of solid shaft between the flat and the flutes. I'm thinking that I should choke up on it such that the open end of the collet sees a full round shank.
The other / back end of the shank is about .4 and less that 2X the diameter. It seems like a bad idea to have only that in the collet.
Am I over thinking this?