- Joined
- Nov 17, 2013
- Messages
- 36
I found a set of used Tormach TTS tooling on another forum and was able to pick it up for $250.
It looks like a good deal to me but I am new to machining and I didn't know for sure. Figured I would post it here and see how I did.
1 TTS-R8 adaptor collet
5 TTS Set screw holders - 5/16, 1/4, 3/8, 1/2 and 5/8
1 TTS Drill Chuck - 1/2" - JT6 (1)
1 TTS-JT6 with ATC geometry
2 TTS Machinable Blank
3 TTS-ER16
2 ATP flycutters - 2" and 2 1/2"
1 Iscar 30mm 3-flute Facemill (Made using a TTS blank
9 ER16 collets 1/32" to 3/8".
2 Homemade tool racks
5 HSS Blanks
It looks like a good deal to me but I am new to machining and I didn't know for sure. Figured I would post it here and see how I did.
1 TTS-R8 adaptor collet
5 TTS Set screw holders - 5/16, 1/4, 3/8, 1/2 and 5/8
1 TTS Drill Chuck - 1/2" - JT6 (1)
1 TTS-JT6 with ATC geometry
2 TTS Machinable Blank
3 TTS-ER16
2 ATP flycutters - 2" and 2 1/2"
1 Iscar 30mm 3-flute Facemill (Made using a TTS blank
9 ER16 collets 1/32" to 3/8".
2 Homemade tool racks
5 HSS Blanks