- Joined
- Jul 14, 2017
- Messages
- 2,448
I live in a country where most of the vehicles are FWD and there are no driveshaft shops. I'm in the middle of refurbishing the rear axle on a small 4x4 ( Little Niva) and when the rear driveshaft is out i want to check if, there is lots of vibrations when driving it, i do own a decent size lathe for holding the driveshaft at the chuck i can get a diff flange and hold it that way, but at the tailstock i'll have to think of something. The driveshaft is one piece with a slip joint and normal style u joints i'll put a picture down. Any advice on how to mount it check it is much appreciated.