- Joined
- Dec 6, 2015
- Messages
- 26
So I recently did a job that required me to reset the angle on my compound a few dozen times. It was a bit hard to read at times, so I got out some black acrylic paint and decided to fill in the engraving for the compound.
I know I could have probably done a better job of getting all the very fine chips out, but I can always come back with some acetone later and redo it.
I think it came out pretty decent.
I know I could have probably done a better job of getting all the very fine chips out, but I can always come back with some acetone later and redo it.
I think it came out pretty decent.