Vevor VFD questions

[randyjaco]

I am in the process of setting up a 3 phase wood planer to single phase with a VFD. My electrical skills are minimal, but I have done this several times with other VFDs. Well, it seems that Vevor has its own way of doing things. I am trying to set up a simple VFD remote control. As you can see from the picture; there is an On/Off switch and a rheostat speed control. I can't figure out to connect the wires from the remote to the VFD. The symbols and locations are different on the Vevor

 

[strantor]

If speed responds backwards (speed goes up when you turn the dial down) then swap red and green.

 

[markba633csi]

Red is CW (clockwise) so that one should go to 5v out, green CCW to gnd, orange to center wiper 5v in

 

[ddickey]

You could just take the faceplate off and use that. You'd need to buy a connector though.

 

[randyjaco]

Thanks Guys for the quick responses. I will do my best to keep the blue smoke inside.