after reading my post a bearly understand my self what i wrote :thinking:
so here i go again
on the old continent we got 220V mono for home use 3x220v (old configuration ) ore 3x380v+N (indistrial power )
i bought a lathe withe a 3x220 V motor with a transformator so it runs on the 380 V now
in my workshop where i want to install the lathe i only got 220V mono
i can install the 380 option but then i need to run a 380v line to my workshop ( instalation in electrical cabinet + 60 yrds to my shop with al the hardware and manhours i think 500-700 $)
so i was thinking on the VFD option so i can run it on the 220V mono (250 $) but way more controle on the lathe speed etc. )
only drawback is from what read here is that i can not use the original lever without rewiring it .
i understand i can rewire it so the originale lever can act like a the remote controle from the VFD
i probably lose the dual speed function from the lever but F/O/R will do also
how do i do that ?
View attachment 44541