O
ome
Forum Guest
Register Today
Hi guys,
The vertical 1.25" OD steel shaft, is not hardened, but brand new. The machine is a die filer, and the few different accessories will leave marks in too many locations to grind flats.
My only idea was to take a small piece of round brass stock, and put it in the tapped hole in front of the set screw.
Any advice would be appreciated.
Thank You,
Jon
The vertical 1.25" OD steel shaft, is not hardened, but brand new. The machine is a die filer, and the few different accessories will leave marks in too many locations to grind flats.
My only idea was to take a small piece of round brass stock, and put it in the tapped hole in front of the set screw.
Any advice would be appreciated.
Thank You,
Jon