- Joined
- Oct 6, 2012
- Messages
- 486
If you want light on only when the switch is on: Pin 1: Load (switched). Pin 2: Line in. Pin 3: Neutral. I wired mine the 2nd way to control a light that is out of view of the switch. Works well.
As I understad this, Pin 1 will be the power from the switch to the power supply, Pin 2 will be the power from the power plug and Pin 3 will be the neutral from the power plug. I will be grounding the common ground from the power plug to the frame of the case. Is this correct?
And I presume that the neutral wire will then go from Pin 3 to the neutral pin on the power supply?
Last edited: