Installing the bearing spacer into the bull gear bearing sleeve. Set it on the inner race of the bottom bearing.
This is how I press my bearings into place. Using a large 3/4" drive socket. Pressing only on the outer race.
Press a new 6908 double sealed bearing into place. Fully seated on to the snap ring.
Bearing spacer in place.
Installing the bearing spacer into the bull gear bearing sleeve. Set it on the inner race of the bottom bearing.
Installing the bearing spacer into the bull gear bearing sleeve.
Installed bearing in the bottom of the bull gear bearing sleeve. View one.
Installed bearing in the bottom of the bull gear bearing sleeve. View two.
expressline99

Installing the bearing spacer into the bull gear bearing sleeve. Set it on the inner race of the bottom bearing.

Media information

Album
Bridgeport Series 1 VS 2hp Rebuilding the Gear Housing
Added by
expressline99
Date added
View count
439
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/5.6
Focal length
6.3 mm
Exposure time
1/60 second(s)
ISO
200
Flash
On, fired
Filename
DSCN5297.JPG
File size
2.2 MB
Date taken
Sun, 02 April 2017 4:55 PM
Dimensions
3648px x 2736px

Share this media

Back
Top