Good day all,
I just bought my first lathe, a Vevor 8x14. it has been ground and trued up quite well prior to my purchase. There are a few things i do want to get for it, first being a quick change tool post and a four jaw chuck (So many on Amazon). Also the speed control knob starts the motor at about 300 rpm rather than 50 or thereabouts.
Im asking advice on which tool posts and chucks would fit right up without modification, and is there a low end adjustment for the motor speed? Ive looked out in the ether and there seems to be little to zero info or manuals for these lathes out there. So looking forward to learning ! Thanks in advance!
Mark
I just bought my first lathe, a Vevor 8x14. it has been ground and trued up quite well prior to my purchase. There are a few things i do want to get for it, first being a quick change tool post and a four jaw chuck (So many on Amazon). Also the speed control knob starts the motor at about 300 rpm rather than 50 or thereabouts.
Im asking advice on which tool posts and chucks would fit right up without modification, and is there a low end adjustment for the motor speed? Ive looked out in the ether and there seems to be little to zero info or manuals for these lathes out there. So looking forward to learning ! Thanks in advance!
Mark