What Did You Buy Today?

[GrifterGuru]

Dropped for a quality 1-10mm chuck plus an arbor. Hard to beat a Rohm chuck for quality. never use anything else if I can help it.



That now makes a 1.5 - 13mm Rohm, plus this 1-10mm rohm. Just have to prepare my wallet for the shock of buying the 20mm Rohm now....

And to think, this all started with a chuck that was robbed from a dead Bosch drill over 35 years ago and used on many drills over the years until I finally decided to use it for my lathe!

 

[682bear]

Three boxes of milling cutters...















There is a good many angle and radius cutters and a good many involute gear cutters. Most look to be useable... a few are not... all are dirty.

Overall, there was about 100 pounds...

-Bear

 

[GrifterGuru]

Good grief! Looking at that little haul, it seems like you will need shares in Evaporust and Thinners!

 

[verbotenwhisky]

Well, my new Universal Dividing head finally made it to the garage. I bought this from Precision Mathews and it is a very nice unit. I can use it for dividing and indexing as it is but I have a few mill related issues to work out before I can use it for spiral cuts. I am very happy with it at this point.

For those of you who might be looking at these this one is the BS-2 and it is setting on my PM940V Mill table for scale.

 

[GrifterGuru]

 

[Just for fun]

 

[GrifterGuru]

What Size ER are those??? or are they a different collet type?

 

[Just for fun]

ER40

 

[Mauzinette]

Hard to beat a Rohm chuck for quality.

I agree. They also have a wide array of other brilliant products for workpiece holding etc.

If I was rich, I’d give Albrecht a go. Now the only thing I can afford from them, is the catalog

 

[mmcmdl]

A new hot water heater .