- Joined
- Nov 16, 2012
- Messages
- 5,596
Oh yes, let's not forget about unit called a "damnit" which can exist in any of the decimal places.
This is the unit that starts out at some value and mysteriously changes... usually something like a shaft diameter that that was decreasing gradually and supposed to stop at say 1.2500" but suddenly disobeyed user commands and stopped at 1.2499. Damnit! I find the best way to change the value of the damnit is to use a different mic or leave the part under the halogen worklight for a long time..
Ray
This is the unit that starts out at some value and mysteriously changes... usually something like a shaft diameter that that was decreasing gradually and supposed to stop at say 1.2500" but suddenly disobeyed user commands and stopped at 1.2499. Damnit! I find the best way to change the value of the damnit is to use a different mic or leave the part under the halogen worklight for a long time..
Ray