It has no use, and pretty much no value.Thanks for the replies, guess I'm not sure what dose what the RT , DH ,SS , I have what I think is called a 5c spin indexer it has 2-1/4" X 10 tpi Chuck mount on it and 5c holder in it I think.
View attachment 114789
What would this be good for.
Thanks
Hi all, is there a good way to set up " tram " the 5c indexer on the mill ?. I was thinking insert shaft into appropriate 5c collet and indicate off it ,is that ihow it's done .? Needing to make hex on end of shaft. This unit is a hardinge and has a 2-1/4" X 10 tpi mount on it , I don't have a Chuck that fits it yet.
I guess this should be in the beginners section move if appropriate.
Thanks
Joshua I'll throw this on santa's sleigh next time he passes by for ya.