- Joined
- Jul 8, 2019
- Messages
- 12
I picked it up in Bellingham wa two weeks ago, oils from Granger, did the setup, leveled and bolted down, put a new 1/2" tool in holder and parked in front of chuck,,,,,,,,,
at this point i could have cried,,, tool centers about .3 above center of chuck,,,,,,,, tail stock is centered, Heard from others a q.c.t.p. set may help... Had this airlifted from grizzly, mod.# T10166 hahaha it is taller than the 4 post, if installed would be about .4 above center. For grins picked up from H.F. .25" tools and they are about .15 above center.......meanwhile the boring set arrived along with a .75" drill chuck haha. Emailed tech support today will see what they say... Any one else have this problem and if so was their a fix with out milling tools and holders down ???
if no fix will be looking for a good small lathe about this size
at this point i could have cried,,, tool centers about .3 above center of chuck,,,,,,,, tail stock is centered, Heard from others a q.c.t.p. set may help... Had this airlifted from grizzly, mod.# T10166 hahaha it is taller than the 4 post, if installed would be about .4 above center. For grins picked up from H.F. .25" tools and they are about .15 above center.......meanwhile the boring set arrived along with a .75" drill chuck haha. Emailed tech support today will see what they say... Any one else have this problem and if so was their a fix with out milling tools and holders down ???
if no fix will be looking for a good small lathe about this size