- Joined
- Jul 6, 2018
- Messages
- 23
Hey guys,
I have an arbor that needs either repaired or re-made. It's for a 1950's Delta/Rockwell Table saw. I have searched everywhere for a replacement to no avail. Unfortunately, my old 10" Atlas lathe is still being rebuilt and I'm also not confident in my ability yet.
Cool Back story on the Table Saw is it came from the lumber mill that built West Virginia Tech and the surrounding towns of Montgomery and Smithers WV. It’s nice to keep history in use.
Sometime during its life the set screw for the pulley came out and what I'm assuming to keep production going is they plugged welded the set screw hole, thus welding the key and the pulley to the arbor shaft. So, In the middle of rebuilding it and trying to replace the arbor bearings the pulley had to be cut damaging the arbor.
I’d like to have the damaged area welded turned and key way cut or if you guys think I should just have a new one made?
Could someone give me a price to do the repair or make a new one.?
thanks in advance,
Stefen
I have an arbor that needs either repaired or re-made. It's for a 1950's Delta/Rockwell Table saw. I have searched everywhere for a replacement to no avail. Unfortunately, my old 10" Atlas lathe is still being rebuilt and I'm also not confident in my ability yet.
Cool Back story on the Table Saw is it came from the lumber mill that built West Virginia Tech and the surrounding towns of Montgomery and Smithers WV. It’s nice to keep history in use.
Sometime during its life the set screw for the pulley came out and what I'm assuming to keep production going is they plugged welded the set screw hole, thus welding the key and the pulley to the arbor shaft. So, In the middle of rebuilding it and trying to replace the arbor bearings the pulley had to be cut damaging the arbor.
I’d like to have the damaged area welded turned and key way cut or if you guys think I should just have a new one made?
Could someone give me a price to do the repair or make a new one.?
thanks in advance,
Stefen