I have accumulated more tool holders than my original rack will hold. Therefore I made this one. It is a 48" piece of Unistrut bolted to the lip of the lathe back splash so it is on a slope. Two 10-32 screws hold each piece of 1 1/2" aluminum angle, cut from salvaged scrap, on my cold saw. Took a lot of spotting, drilling, tapping, deburring!
The photo was taken before I made the last 6 angles to totally fill out. Now easier to see and grab.
The photo was taken before I made the last 6 angles to totally fill out. Now easier to see and grab.