- Joined
- Mar 3, 2013
- Messages
- 1,448
So I need to thread the both ends of a piece of 5/8" 316 SS Rod. Single pointing is not an option since the rod is too long for my lathe location. One end is right hand and the other left hand. Both are 5/8"-18 thread.
1) Is cutting about 5" of thread on each end with a hand die in 316 a crazy idea?
2) I assume HSS dies would be required, I would need to purchase both LH & RH any suggestions on brand or vendor?
3) Any suggested cutting fluid to make the job easier?
1) Is cutting about 5" of thread on each end with a hand die in 316 a crazy idea?
2) I assume HSS dies would be required, I would need to purchase both LH & RH any suggestions on brand or vendor?
3) Any suggested cutting fluid to make the job easier?