Hello All, I purchased an Atlas 618 lathe a while a go. Was stored in a barn for more than 30 years waiting for a new owner. Was pretty rusty but it cleaned up very nicely with very little wear. The only issue i have is that the thread chasing dial is missing,
Does anyone here know of or have a drawing the assembly that i could manufacture one from? I know its not a big issue to make one without a drawing, but a drawing would make things easier.
Any info will be greatly appreciated.
Does anyone here know of or have a drawing the assembly that i could manufacture one from? I know its not a big issue to make one without a drawing, but a drawing would make things easier.
Any info will be greatly appreciated.