Ok, SirA normal press fit would be to make hole 0.025 mm smaller than the pin in this size range. You could go maybe 0.050mm undersize on the hole. Smaller than that I think the the pin won't fit well.
Nice job on the spanner.
Thank U KDI have made spanners using dowel pins pressed in. If they work lose we just tack them with tig from the back.
Hello MIKEI've made spanners for differential work. A light press fit, and weld from the back side works pretty well. As suggested I would re-drill the holes in the flange for a tight fit. After making the first spanner the second one will be easier, or grind the pins off and re-drill for the original size of the new part. Would like to see some pics of the machine if you get a chance. Mike
Thanks JIMThat is a nice looking grinder! The same size as my DoAll. Never seen one with a 2 speed motor before, the slower speed would be great for sharpening HHS wood cutting blades.
Hello BILLI agree with the other writers, that has to be left-hand thread otherwise it could come unscrewed when your back is turned. When you get it off and cleaned up/refaced mark it either with a arrow or stamp "L.H" on the outer face. Take your time to clean and repair the stops. Double check to see if there are stops under the table to control travel in and out. Some grinders do, some are fixed for the maximum travel. Looks like a nice grinder.
Get some paper wheel blotters/spacers to go between the grinding wheel and metal shoulders. We were thought to always use new papers each time we changed the wheel. Always ring each wheel before mounting it. The easiest is put your finger through the hole and take a medium size screw driver using the handle tap the wheel. It you hear a faint ringing sound then the wheel is safe to use. There are no internal cracks. At least that was what we were taught.