- Joined
- Nov 30, 2017
- Messages
- 20
Hello Everyone
I recently acquired a buck adjust tru 10" chuck for my SB 16. There is some play in the chuck jaws. You can rock them side to side slightly have not put an indicator on but was curious about how much is acceptable. The Jaws tighten fine and flat against the work piece. Since its an adjustable chuck I can center it fine. Just not sure what problems the movement will have when tool pressure is applied. Also had a question about drill chucks. Since my machine is MT3 what would be the maximum drill chuck for the MT3 shank. I was looking at a 18N jacobs. Also a keyless 5/8" is also of interest to me. Was thinking of a Rohm seem much more reasonable than the Albrecth but not sure about the threaded arbor. There are some with integrated shanks that look like the way to go. Thanks in advance for any suggestions.
I recently acquired a buck adjust tru 10" chuck for my SB 16. There is some play in the chuck jaws. You can rock them side to side slightly have not put an indicator on but was curious about how much is acceptable. The Jaws tighten fine and flat against the work piece. Since its an adjustable chuck I can center it fine. Just not sure what problems the movement will have when tool pressure is applied. Also had a question about drill chucks. Since my machine is MT3 what would be the maximum drill chuck for the MT3 shank. I was looking at a 18N jacobs. Also a keyless 5/8" is also of interest to me. Was thinking of a Rohm seem much more reasonable than the Albrecth but not sure about the threaded arbor. There are some with integrated shanks that look like the way to go. Thanks in advance for any suggestions.