couldn't resist time to GLOAT.

author=george wilson link=topic=3668.msg28610#msg28610 date=1317917465
Put a dial indicator on the back surface of the table. Crank the table in so the dial indicator traverses the whole surface. Let me know how much too high the front edge in than the rear edge. I had to send back a Valumaster as the front surface was WAY too high. A little front end bias is expected,maybe .0015". The Valumaster was WAY over that. Can't recall how much. I sent it back and got a Vectrax mill,same model as yours. Still was a bit too high,but I kept it.
Click to expand...
is. 0005 to much?
 
Last edited by a moderator:
You must log in or register to reply here.
Back
Top