- Joined
- Dec 25, 2011
- Messages
- 593
I need to cut some 1.5 mm threads on my SB9a and read some where that if you use a 26 tooth stud gear you could get really close.
So I set about trying to figure out how to cut a gear with the stuff I have. Here are the results below. It's not real pretty but hoping it works. Haven't tried it out yet.
The first one did not work out--my index wheel was off.
So I set about trying to figure out how to cut a gear with the stuff I have. Here are the results below. It's not real pretty but hoping it works. Haven't tried it out yet.
The first one did not work out--my index wheel was off.