Thanks @Janderso, I'm very pleased with it.
From the overall condition of the lathe it's seen very little use. I'm inclined to leave the spindle bearings as they are. I will replace the felts however as that seems prudent.
I appreciate your concern and caution on my behalf, thank you
Looking at your spindle nose, I didn't realize that the 10K had a collet closer built in. I take it that you didn't get a collet drawbar set? I think that it takes 6K collets.
It does take 6K collets. Unfortunately no collets or the closer were included.
Not a huge deal to me as I think I would rather go with ER40 collets and an appropriate chuck.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.