Hi guys.
Just an update on how I fixed the housing based on the advice I got from you guys.
I machinde the housing down about 4mm and 3mm in. I the made a pressfit sleeve slightly oversized on the od and undersize on the id and tapped it onto the housing and clocked everything up.
I then brazed it and machined down to size. It came out better than expected.
Well this beat making a whole new part any day.
Thanks for all your inputand advice.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.