I’m hoping someone can help me out here. I just finished making a 2x72 belt grinder that is powered by a 220v 30 amp VFD. I also have a grizzly mill that is powered by 220v 30 amp. I’d like to have the 220 extension cord that hangs down from the ceiling above both of them power them both but not at the same time. I’d like to have a box I can mount that has two plug ins on it but then has a DPDT switch to control both plug ins. That way I could have both machines plugged in at the same time but use the switch to power the grinder or to the mill or center for off. I also would like this because the vfd for the grinder doesn’t have an off switch. It has to be unplugged to turn off. Wondering if this is even possible. Did some research but can’t come up with much. Thanks for any help.