- Joined
- Jun 21, 2014
- Messages
- 40
The first thing I thought I would do is the tail-stock, it was the easiest part to get off. I tore it all down and cleaned it up, everything is in nice shape except where the tail-stock rides on the ways, there is a groove about .010 deep (see picture). I will probably have to shim it up. I don't think this is the original tail-stock because where the tail-stock rides on the ways I can still see the scraping. I also can't quite make out the tail-stock number on the serial number card.
Before
After, as if you couldn't tell.
I also cleaned up a few small parts.
Almost forgot, does anyone know what the hole is for near the quill across from the locking lever??
Before
After, as if you couldn't tell.
I also cleaned up a few small parts.
Almost forgot, does anyone know what the hole is for near the quill across from the locking lever??
Last edited: