Thanks guys.
I used a HSS vertical sheer tool for the turning and carbide for the facing.
I had a quick look tonight and I've decided to go back and start again. I checked the runout on the spindle mounting face 0.01mm, pulled the jaws off the 3 jaw and checked the runout at the chuck face 0.05mm. Rotated the chuck in the spindle and the runout changed I got it down to 0.02mm. So this weekends job is to markup the spindle and check the mount, and put the chuck on the surface plate to check it.
I used a HSS vertical sheer tool for the turning and carbide for the facing.
I had a quick look tonight and I've decided to go back and start again. I checked the runout on the spindle mounting face 0.01mm, pulled the jaws off the 3 jaw and checked the runout at the chuck face 0.05mm. Rotated the chuck in the spindle and the runout changed I got it down to 0.02mm. So this weekends job is to markup the spindle and check the mount, and put the chuck on the surface plate to check it.
Last edited: