- Joined
- Jan 8, 2016
- Messages
- 171
If I tighten the compound slider and then turn the adjustment knob in the other direction there is about .004” (according to the dial) before it engages and moves the slide. This is not thread backlash but appears to be slop between the washer and the frame of the slider shown here:
Anyone know of a solution? Can the washer be pressed on tighter? Remove the washer and shim behind it? If so how does it come apart?
I have not tried anything at this point, just hoping someone has seen this problem and has a solution.
Anyone know of a solution? Can the washer be pressed on tighter? Remove the washer and shim behind it? If so how does it come apart?
I have not tried anything at this point, just hoping someone has seen this problem and has a solution.