Hello guys I'm new to this forum and very green to milling metals. I picked up a older bridgeport copy mill and need a way to clamp my first project.
I need to clamp this upper reciever to open up the port to .550. The cheaper drill press vise I have is not deep enough. Would flat stock hold or should I make deeper jaws? I'm nervous that I might ruin a two hundred dollar upper If it's not done right.
Thanks Ed
I need to clamp this upper reciever to open up the port to .550. The cheaper drill press vise I have is not deep enough. Would flat stock hold or should I make deeper jaws? I'm nervous that I might ruin a two hundred dollar upper If it's not done right.
Thanks Ed