- Joined
- Oct 4, 2016
- Messages
- 7,062
I am pretty much a functioning illiterate(kind of embarrassing) when it comes to math, it's pretty much the reason I'm the resident hack. Anyway I need to bend a 1/8" x 4" 316 SS flat plate that needs to have 2 90* bends, and have a + or - loose close tolerance of 10" between them. I'm not sure of where to mark the line to include the bend radius, so I get the 10" outside measurement, I have a mental block looking at the formulas, and K factors etc., can someone make sense of this for me? I am this using the Swag press brake.