- Joined
- Oct 17, 2018
- Messages
- 922
I have an older Atlas Craftsman lathe (101.07403 made in 1944) and am not comfortable using the usual knurler that is pressed from the side. It puts too much pressure on the bearings and I'm afraid it will push the part off the center if I try to get a deep knurl. So, I'd like to get a different style.
There are two: scissor and clamp. Any preference? Any brand I should look at? They all seem to be the same one sold by different vendors at different prices.
There are two: scissor and clamp. Any preference? Any brand I should look at? They all seem to be the same one sold by different vendors at different prices.