- Joined
- Jan 22, 2022
- Messages
- 144
Probably a dumb question…
I just got around to leveling my Clausing 13” lathe. Bought a Starrett level and big wrench. Then I noticed my leveling “feet” are just rounded bolt ends. I don’t want that digging into my garage floor.
After some googling and eBaying I found these leveling pads.
Is it possible I could just turn some stainless steel bar and add a little divot for the bolts? Or is there something special about these machine foot pads?
I just got around to leveling my Clausing 13” lathe. Bought a Starrett level and big wrench. Then I noticed my leveling “feet” are just rounded bolt ends. I don’t want that digging into my garage floor.
After some googling and eBaying I found these leveling pads.
Is it possible I could just turn some stainless steel bar and add a little divot for the bolts? Or is there something special about these machine foot pads?